20 Zeilen
792 B
Markdown
20 Zeilen
792 B
Markdown
## SNAT
|
|
|
|
SNAT is used to change the source address of the packets sent by mailcow.
|
|
It can be used to change the outgoing IP on systems with multiple IP addresses.
|
|
|
|
Open `mailcow.conf`, set either or both of the following parameters:
|
|
|
|
```
|
|
# Use this IPv4 for outgoing connections (SNAT)
|
|
SNAT_TO_SOURCE=1.2.3.4
|
|
|
|
# Use this IPv6 for outgoing connections (SNAT)
|
|
SNAT6_TO_SOURCE=dead:beef
|
|
```
|
|
|
|
Run `docker-compose up -d`.
|
|
|
|
The values are read by netfilter-mailcow. netfilter-mailcow will make sure, the post-routing rules are on position 1 in the netfilter table. It does automatically delete and re-create them if they are found on another position than 1.
|
|
|
|
Check the output of `docker-compose logs --tail=200 netfilter-mailcow` to ensure the SNAT settings have been applied.
|